Switch - Power Window Sub Rear
- Measure the resistance between terminals of the switch - power window sub rear.
Preparation tool:
Circuit tester
- Rear seat sub
Terminal No. Inspection conditions Standard 1 - 2
5 - 4OFF Less than 1 Ω 3 - 1
3 - 51 MΩ or more 3 - 2
5 - 4Manual UP Less than 1 Ω 3 - 1 1 MΩ or more 1 - 2
3 - 4Manual DOWN Less than 1 Ω 3 - 5 1 MΩ or more - Apply battery voltage between the switch - power window sub rear terminals to check lighting condition of illumination inside the switch.CAUTION: When applying battery voltage, do not mix up the positive (+) side and the negative (-) side.
Incorrect polarity connection may cause LED damage inside the switch.Terminal No. Inspection conditions Standard 3 (+) - 1 (-)
3 (+) - 5 (-)Apply battery voltage. Light ON - Replace the switch - power window sub rear if it is found defective from the inspection result.