Switch - Power Window Sub Front
- Measure the resistance between terminals of the switch - power window sub front.
Preparation tool:
Circuit tester
- Passenger's seat sub
Terminal No. Inspection conditions Standard 6 - 5
6 - 7OFF Less than 1 Ω 2 - 5
2 - 61 MΩ or more 2 - 6
5 - 7Manual UP Less than 1 Ω 2 - 5
6 - 71 MΩ or more 2 - 5
6 - 7Manual DOWN Less than 1 Ω 2 - 6
5 - 71 MΩ or more - Apply battery voltage between the switch - power window sub front terminals to check lighting condition of illumination inside the switch.CAUTION: When applying battery voltage, do not mix up the positive (+) side and the negative (-) side.
Incorrect polarity connection may cause LED damage inside the switch.Terminal No. Inspection conditions Standard 7 (+) - 2 (-) Apply battery voltage. Light ON - Replace the switch - power window sub front if it is found defective from the inspection result.