Body Control System (Diagnostics): Customize: List
CAUTION:
- The setting items must match the actual vehicle equipment.
- Do not change settings except for setting below while setting the functions.
- Be sure not to change Factory initial setting except when installing a new body integrated unit.
| Item | Initial setting value | Setting value | Remarks |
|---|---|---|---|
| Lane change signal setting | Yes | ON OFF |
Yes: One-touch blinker function operates. No: One-touch blinker function does not operate. |
| Driver's Door Unlock Setting | Selection | Selection ALL | Selection: When the touch sensor (unlock) on the driver's side is touched, only the driver's door is unlocked. When the touch sensor (unlock) on the passenger's side is touched, all doors are unlocked. ALL: When the touch sensor (unlock) on the driver's side is touched, all doors are unlocked. When the touch sensor (unlock) on the passenger's side is touched, all doors are unlocked. |
| Select unlock by keyless transmitter operation | ALL | Selection ALL | Selection: Only the driver's door is unlocked when the keyless transmitter is used to unlock. When it is used again, the passenger's side door is also unlocked. ALL: All doors are unlocked when the keyless transmitter is used to unlock. |
| Daytime Running Light (DRL) Setting for North America | Alternate DRL System | High Beam Dimming System Alternate DRL System |
Set according to the daytime running light source type. |
| Wiper link Auto Light Setup | ON | ON OFF |
ON: Wiper interlock auto light function is activated. OFF: Wiper interlock auto light function is not activated. |
| Steering Wheel | Left | Left Right |
Factory setting item |
| P/W ECU Setting | Driver's seat, passenger's seat | No Driver's seat Driver's seat, passenger's seat |
No: Not equipped with power window ECM. Driver's seat: Equipped with power window ECM on driver's seat only. Driver's seat, passenger's seat: Equipped with power window ECM only on driver's seat and passenger's seat. Factory setting item |
| High Beam Assist Current Setting | ON | ON OFF |
ON: HBA operates. OFF: HBA does not operate. |
| High Beam Assist Function Setting (mirror/EyeSight) | No HBA | No HBA EyeSight HBA |
No HBA: HBA does not operate. With EyeSight HBA: HBA operates. Factory setting item |
| Rear defogger operation mode | Normal | Normal Continuous |
Normal: Automatically stops in 15 minutes after the switch is turned to ON. Continuous: Repeats the cycle of 15-minute active condition and 2-minute inactive condition until the switch is turned to OFF. |
| Security Alarm Setup | OFF | ON OFF |
ON: Warning function (hazard, horn) is activated. OFF: Warning function (hazard, horn) is deactivated. |
| Lockout prevention | ON | ON OFF |
ON: Key lockout prevention function is activated. (The function does not operate if safety knob is locked by hand.) OFF: Key lockout prevention function is deactivated. |
| Buzzer sounding setting | ON | ON OFF |
ON: Buzzer sounds when lock/unlock is selected by keyless entry system. OFF: Buzzer does not sound when lock/unlock is selected by keyless entry system. |
| Abnormal warning lamp flashing setting | ON | ON OFF |
ON: Hazard blinks when lock/unlock is selected by keyless entry system. OFF: Hazard does not blink when lock/unlock is selected by keyless entry system. |
| Door open warning | Yes | Yes No |
Yes: If a door stays half shut for 20 minutes, map light interlocked with the door goes out to prevent battery runout. No: Map light and door warning light remain lit with a door half shut. |
| Auto A/C Setting | Yes | ON OFF |
Yes: Auto A/C operates. No: Auto A/C does not operate. |
| Sedan/Wagon Setting | Sedan | Sedan Wagon |
Factory setting item |
| MT/AT Setting | AT | AT MT |
Factory setting item |
| Destination Setting | U.S.: U4, U5, U6 Canada: C0, C5 |
JPN KA, KC Europe LHD models except for KS C0, C5 U4, U5, U6 EK, ER C6 |
Factory setting item |
| Factory initial setting | Market | Factory Market | Factory: Factory mode Market: Market mode |
| Welcome Light Off Delay Time (Exiting) | 30 seconds | OFF 30 seconds 60 seconds 90 seconds |
Lighting time length of the welcome lighting (exit) function can be set. |
| Welcome Light Off Delay Time (Approaching) |
30 seconds | OFF 30 seconds 60 seconds 90 seconds |
Lighting time length of the welcome lighting (approaching) function can be set. |
| Auto Dimmer Cancel setting | Normal | OFF Least Less Normal More Most |
Auto dimmer cancel function sensitivity can be set. |
| Illumination Sensor Setting | Yes | ON OFF |
Yes: Auto light operates. No: Auto light does not operate. |
| Lighting Time | 15 sec | 15 sec 7.5 sec 30 sec |
Setting is possible for the amount of map light illumination time when the SW is set to DOOR. |
| Room Light ON by ACC OFF | Yes | Yes No |
Yes: Enables map light illumination when the SW is set to DOOR and the ACC is OFF. No: Disables map light illumination when the SW is set to DOOR and the ACC is OFF. |
| Room Light ON by Door Unlock | Yes | Yes No |
Yes: Enables map light illumination when the SW is set to DOOR and the door is unlocked. No: Disables map light illumination when the SW is set to DOOR and the door is unlocked. |
| Room Light ON by Approaching | Yes | Yes No |
Yes: Enables map light illumination when the SW is set to DOOR and the vehicle is approached. No: Disables map light illumination when the SW is set to DOOR and the vehicle is approached. |
| Keyless Control | Yes | Yes No |
Yes: Enables the door lock by the keyless transmitter operation. No: Disables the door lock by the keyless transmitter operation. |
| Open Door Warning | Yes | Yes No |
Yes: Enables the open door warning function. No: Disables the open door warning function. |
| Panic Function | Yes | Yes No |
Yes: Enables the panic alarm function. No: Disables the panic alarm function. |
| Keyless Trunk Unlock | Push and hold (short) | One short push Two short pushes Push and hold (short) Push and hold (long) |
Keyless transmitter-operated trunk open can be selected. |
| Keyless Buzzer Volume | 5 | 1 - 7 | Buzzer volume can be set. |
| Auto Light Sensitivity | 0% | +40% +20% 0% -20% -40% |
+40%: Very sensitive +20%: Sensitive 0%: Standard -20%: Insensitive -40%: Very insensitive The higher the set value, the easier the light turns on. |
| DRL Control | ON | ON OFF |
ON: Enables the DRL control. OFF: Disables the DRL control. Setting available for U.S. models only. |
| Interior Light Control | Yes | Yes No |
Yes: Enables the map light illumination function when the SW is set to DOOR. No: Disables the map light illumination function when the SW is set to DOOR. |
| Car Finder Function | Yes | Yes No |
Yes: The vehicle position detecting function operates. No: The vehicle position detecting function does not operate. |
| SUBARU/Toyota Setting | Toyota | SUBARU/Toyota | Factory setting item |