LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2023 >> Ascent Base >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Body Control System (Diagnostics) >> Customize >> List

Body Control System (Diagnostics): Customize: List

CAUTION:
  • The setting items must match the actual vehicle equipment.
  • Do not change settings except for setting below while setting the functions.
  • Be sure not to change Factory initial setting except when installing a new body integrated unit.
Data Initial setting value Customize setting Remarks
Off delay time 30s OFF 10 Sec 20 Sec 30s Room light off delay time can be selected.
Auto Light Sensitivity Adjustment Sensitive Dull Normal Sensitive Very sensitive Sensitivity of the automatic lighting can be adjusted.
Remote Trunk Open/Power Rear Gate Open Function Press and hold OFF Press twice Press and hold Keyless transmitter-operated trunk open/power rear gate open can be selected.
Power rear gate setting ((1)) ON OFF Yes: Equipped with power rear gate. No: Not equipped with power rear gate.
Lane change signal setting ON ON OFF ON: One-touch blinker function operates. OFF: One-touch blinker function does not operate.
Rear wiper auto setting ((1)) ON OFF ON: Rear wiper operates in sync with the reverse shift, when the front wiper is at continuous wiping. OFF: Rear wiper does not operate in sync with the reverse shift, when the front wiper is at continuous wiping.
Driver's Door Unlock Setting Selection Selection ALL Selection: When the touch sensor (unlock) on the driver's side is touched, only the driver's door is unlocked. When the touch sensor (unlock) on the passenger's side is touched, all doors are unlocked.
ALL: When the touch sensor (unlock) on the driver's side is touched, all doors are unlocked. When the touch sensor (unlock) on the passenger's side is touched, all doors are unlocked.
Rear Gate Unlock Setting Selection Selection ALL Selection: When the rear gate opener button is pressed, only the rear gate is unlocked.
ALL: When the rear gate opener button is pressed, all doors are unlocked.
Daytime Running Light (DRL) Setting for North America Low Beam Dimming System High Beam Dimming System Low Beam Dimming System Alternate DRL System Set according to the daytime running light source type.
Wiper link Auto Light Setup ON ON OFF ON: Wiper interlock auto light function is activated. OFF: Wiper interlock auto light function is deactivated.
Steering Wheel Left Left Right Left: Left hand drive.
Right: Right hand drive.
Vehicle Automatic Door Lock Vehicle Speed Sensor OFF Vehicle Speed Sensor Select Lever P OFF: Vehicle automatic door lock is not activated. Vehicle Speed Sensor: Vehicle automatic door lock is activated at or above a certain vehicle speed. Select Lever P: Vehicle automatic door lock is activated when the select lever is shifted from P to other than P.
Vehicle Automatic Door Unlock Driver Door Open OFF Select Lever P Power OFF Driver Door Open OFF: Vehicle automatic door unlock is not activated. Select Lever P: Vehicle automatic door unlock is activated when the select lever is shifted from P to other than P. Power OFF: Vehicle automatic door unlock is activated when the IGN is turned from ON to OFF. Driver Door Open: Vehicle automatic door unlock is activated when the driver's door is operated from Close to Open.
P/W ECU Setting ((1)) OFF Driver Seat
Driver/Passenger Seat [Four Seat]
OFF: Not equipped with power window ECM.
Driver Seat: Equipped with power window ECM on driver's seat only. Driver/Passenger Seat: Equipped with power window ECM only on driver's seat and passenger's seat. Four Seat: Equipped with power window ECM on all four seats.
Sunshade ECU Setting ((1)) ON OFF ON: Equipped with sunshade. OFF: Not equipped with sunshade.
Ambient Light Setting ON ON OFF Set to Yes for all vehicles.
Ambient Light Setup ON ON OFF Ambient light is activated. Ambient light is not activated.
Head Lamp Low Beam Specification LED Halogen HID LED Set to LED for all vehicles.
Head Lamp High Beam Specification LED Halogen HID LED Set to LED for all vehicles.
High Beam Assist Current Setting ON ON OFF When High Beam Assist Function Setting (mirror/EyeSight) is set to other than No HBA, ON: High beam assist is activated. OFF: High beam assist is not activated.
High Beam Assist Function Setting (mirror/EyeSight) EyeSight HBA No HBA EyeSight HBA mirror HBA Set according to the vehicle.
Rear defogger operation mode 15 minutes (normal) Normal Continuous Normal: Automatically stops in 15 minutes after the switch is turned to ON. Continuous: Repeats the cycle of 15-minute active condition and 2-minute inactive condition until the switch is turned to OFF.
Security Alarm Setup ON ON OFF ON: Warning function (hazard, horn) is activated. OFF: Warning function (hazard, horn) is deactivated.
Alarm delay setup ON ON OFF ON: The alarm monitor starts 30 seconds after the keyless lock operation.
OFF: The alarm monitor starts immediately after the keyless lock operation.
Lockout prevention ON ON OFF ON: Key lockout prevention function is activated. (The function does not operate if safety knob is locked by hand.) OFF: Key lockout prevention function is deactivated.
Buzzer sounding setting ON ON OFF ON: Buzzer sounds when lock/unlock is selected by keyless entry system. OFF: Buzzer does not sound when lock/unlock is selected by keyless entry system.
Abnormal warning lamp flashing setting ON ON OFF ON: Buzzer sounds when lock/unlock is selected by keyless entry system. OFF: Buzzer does not sound when lock/unlock is selected by keyless entry system.
Door open warning ON ON OFF ON: If a door stays half shut for 20 minutes, interior lighting linked with the door such as reading light, map light and luggage room light go off to prevent battery run-out. OFF: Reading light, map light, luggage room light and door warning light remain lit.
Dome Light Alarm Setting OFF ON OFF ON: Reading light, map light, luggage room light and ambient light illumination are interlocked with the alarm. OFF: Reading light, map light, luggage room light and ambient light illumination are not interlocked with the alarm.
Auto A/C Setting Support ON OFF ON: Equipped with auto A/C control module. OFF: Not equipped with auto A/C control module.
Wiper Deicer setting ((1)) ON OFF ON: With wiper deicer function. OFF: Without the wiper deicer function.
Rain drop Detection Sensor Setting - ((1)) ON OFF ON: Equipped with rain drop detection sensor.
OFF: Not equipped with rain drop detection sensor.
Seat Memory Setting - ((1)) ON OFF ON: Equipped with seat memory.
OFF: Not equipped with seat memory.
Illumination Sensor Setting Support ON OFF ON: Equipped with illumination sensor.
OFF: Not equipped with illumination sensor.
Factory initial setting Market Factory Market Factory: Factory mode. Market: Market mode.
Auto Wiper/INT Setting AUTO INT AUTO INT: Performs the front wiper INT drive. AUTO: Performs the front wiper AUTO drive.
EPB setting ON ON OFF ON: Equipped with EPB. OFF: Not equipped with EPB.
Sunroof setting ((1)) ON OFF ON: Equipped with sunroof. OFF: Not equipped with sunroof.
Welcome Light Off Delay Time (Exiting) 30 Sec OFF 30 Sec 60 Sec 90 Sec Lighting time length of the welcome lighting (exit) function can be set.
Welcome Light Off Delay Time (Approaching) 30 Sec OFF 30 Sec 60 Sec 90 Sec Lighting time length of the welcome lighting (approaching) function can be set.
Keyless Buzzer Volume 5 1 - 7 Buzzer volume can be set.
Auto Dimmer Cancel Setting 3 0 (OFF) Least Less Normal More Most Auto dimmer cancel sensitivity can be set.
Security horn sound ON ON OFF ON: The horn sounds. (Except for horn switch factors)
OFF: The horn does not sound. (Except for horn switch factors)
(1) Customization item according to the actual vehicle equipment