Execution Condition
| Secondary parameters | Execution condition |
|---|---|
| 12 V battery system voltage | 10 V or more |
| Accelerator pedal position (from ECM) | 0.959 deg or less |
| Pulley ratio | 2.0 or more |
| Commanded duty of torque converter clutch pressure control solenoid | 0% or less |
| Transmission fluid temperature | -10 °C or more and 120 °C or less |
| Engine speed* *Latch condition: This condition does not reset until the ignition switch is turned off or Engine Start & Stop System is activated. |
400 rpm or more |
| Measured turbine shaft speed** **Latch condition: This condition does not reset until the state below (Measured turbine shaft speed for time.) |
400 rpm or less Condition higher than 400 rpm for 0.2 sec |
| Measured turbine shaft speed*** ***Latch condition: This condition does not reset until the state below (Measured turbine shaft speed for time.) |
Higher than 0 rpm Condition 0 rpm or lower for 0.1 sec |
| Transmission range | Drive or Reverse |
| Inhibit condition**** ****(If change in vehicle speed or ABS [change in vehicle acceleration] activated for time) |
-3 m/s2
or less VEHICLE SPEED SPECIFICATION m/s3 or more 20 sec |
| Cold Start | Not in operation |
| Engine Start/Stop System stops engine | Not in operation |
VEHICLE SPEED SPECIFICATION
| Vehicle speed (MPH) | 0 | 20 | 40 | 60 | 80 |
|---|---|---|---|---|---|
| Change in vehicle acceleration (m/s3 ) | 130 | 130 | 130 | 130 | 130 |