LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2022 >> WRX Base, Standard Trans >> Repair and Diagnosis >> Body & Frame >> Seat System - Seats >> Seat Heater >> Removal >> Rear Seat Heater Control Module

Rear Seat Heater Control Module

CAUTION:
  • Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to  AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION 
  • Side impact sensor (under the rear center seat) for the airbag system is located under the front center of the rear seat cushion. Be careful not to apply strong impact to the sensor when working with the rear seat cushion removed. 
  1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Ref. to REPAIR CONTENTS>NOTE>BATTERY
  2. Remove the trunk trim panel side RH. Ref. to EXTERIOR/INTERIOR TRIM>TRUNK ROOM TRIM>REMOVAL
  3. Remove the rear seat heater control module.
    1. Disconnect the connector.
    2. Remove the bolt and the rear seat heater control module.
      G14612750Courtesy of SUBARU OF AMERICA, INC.