DTC B225A: Center Information Display

DTC detecting condition: 

Detected when the center information display has an internal failure.

Trouble symptom: 

Display and operation of the center information display are faulty.

1. CHECK DTC  .
   1. Using the Subaru Select Monitor, perform the clear memory of [Cockpit Control]. Ref. to COMMON (DIAG)>CLEAR MEMORY .
   2. Turn the ignition switch OFF → ON.
   3. Read the DTC of [Cockpit Control] using the Subaru Select Monitor. Ref. to Cockpit Control (Diagnostics)>Diagnostic Trouble Code (DTC) .

   Is DTC B225A displayed? (Current malfunction)

   Yes:  Go to  2 .

   No:  Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

   NOTE:

   In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause. 

2. CHECK CONNECTOR  .

   Check each connector connected to the center information display.

   Is the check result OK?

   Yes:  Replace the center information display. Ref. to ENTERTAINMENT & MONITORING>COCKPIT DISPLAY .

   No:  Repair the harness or replace the components.