LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2022 >> Forester Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (CVT Transaxle System (Tr580) (Wilderness)) >> Primary Pressure Sensor >> Removal

Primary Pressure Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Vehicle components are extremely hot immediately after driving. Be wary of receiving burns from heated parts.
  • If water or oil contacts the connector terminal of primary pressure sensor, replace it with a new part.
  1. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the front wheel RH. Ref. to WHEEL AND TIRE SYSTEM>TIRE AND WHEEL>REMOVAL .
  3. Remove the crossmember support rear RH. Ref. to FRONT SUSPENSION>CROSSMEMBER SUPPORT>REMOVAL .
  4. Disconnect the connector, and remove the primary pressure sensor.
    NOTE: Prepare the container for draining of engine oil.
    G14403593Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the O-ring from the primary pressure sensor.
scientia non olet · About LEMON Manuals