General Tool
| TOOL NAME | REMARKS |
|---|---|
| Wobble extension | Used for installing the brake booster. |
| Cap | Used for brake hose installing portion of caliper body. |
| Crowfoot wrench | Used for installing the brake pipe.
NOTE:
Use Snap-on FRHM10 or FRHM12, or another manufacturer's 12-point wrench.
|
| Circuit tester | Used for measuring resistance, voltage and current. |
| Dial gauge | Used for measuring brake disc run-out. |
| Magnet stand | Used for measuring brake disc run-out. |
| Micrometer | Used for measuring the brake disc thickness. |
| Disc brake piston tool | Used for pushing back the electronic parking brake piston.
|
| Disc brake piston tool | Used for pushing back the piston. (Except for electronic parking brake) |
| Vacuum gauge | Used for measuring the operation and airtightness of the brake booster. |
| Flare nut wrench | Used for removing and installing the brake pipe. |
| Pressure gauge | Used for measuring the operation and airtightness of the brake booster. |
| Hexagon wrench | Used for removing and installing the electronic parking brake caliper. Width across flat 7 mm (0.28 in) |