DTC P0336: Crankshaft Position Sensor "A" Circuit Range/Performance: Notes

-
DTC detecting condition:

Detected when two consecutive driving cycles with fault occur.

Trouble symptom:
- Engine stall
- Failure of engine to start
NOTE: After the faulty parts are repaired or replaced, perform the final check in Basic Diagnostic Procedure. Ref. to ENGINE (DIAGNOSTICS) (H4DO)>BASIC DIAGNOSTIC PROCEDURE>PROCEDURE .
1. CHECK CONDITION OF CRANKSHAFT POSITION SENSOR .
  Check the installation condition of crankshaft position sensor.
  
  Is the crankshaft position sensor installation bolt tightened securely?
  
  Yes : Go to 2.
  
  No : Tighten the crankshaft position sensor installation bolt securely. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>CRANKSHAFT POSITION SENSOR>INSTALLATION .
2. CHECK CRANKSHAFT POSITION SENSOR PLATE .
  Check the crankshaft position sensor plate.
  
  Is there crack or damage in the crankshaft position sensor plate teeth?
  
  Yes : Replace the crankshaft position sensor plate. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>CRANKSHAFT POSITION SENSOR PLATE .
  
  No : Go to 3.
3. CHECK INSTALLATION CONDITION OF TIMING CHAIN .
  Turn the crankshaft, and align alignment mark on crank sprocket with alignment mark on cylinder block.
  
  ST 18252AA000
  
  CRANKSHAFT SOCKET
  
  Is the timing chain dislocated from its proper position?
  
  Yes : Correct the installation condition of timing chain. Ref. to MECHANICAL (H4DO)>TIMING CHAIN ASSEMBLY .
  
  No : Replace the crankshaft position sensor. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>CRANKSHAFT POSITION SENSOR .