Remote Control Mirror Switch: Inspection

Check the resistance between switch door mirror terminals.

Courtesy of SUBARU OF AMERICA, INC.

Changeover switch RH

Terminal No.	Inspection conditions	Standard
2 - 6 2 - 10	OFF	1 MΩ or more
2 - 10 11 - 6	UP	Less than 1 Ω
2 - 11 10 - 6	DOWN	Less than 1 Ω
2 - 12 10 - 6	LEFT	Less than 1 Ω
2 - 10 12 - 6	RIGHT	Less than 1 Ω

Changeover switch LH

Terminal No.	Inspection conditions	Standard
2 - 6 2 - 7	OFF	1 MΩ or more
2 - 7 8 - 6	UP	Less than 1 Ω
2 - 8 7 - 6	DOWN	Less than 1 Ω
2 - 9 7 - 6	LEFT	Less than 1 Ω
2 - 7 9 - 6	RIGHT	Less than 1 Ω

Apply battery voltage between the switch door mirror terminals to check lighting condition of illumination inside the switch.

CAUTION: When applying battery voltage, do not mix up the positive (+) side and the negative (-) side.
Incorrect polarity connection may cause LED damage inside the switch.

Terminal No.	Inspection conditions	Specification
3 (+) - 5 (-)	Apply battery voltage.	Light ON

Replace the switch power window main if it is found defective from the inspection result.