Adjustment Value Clear
WARNING: This page is about a different car, the 2021 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.
Perform when replacing stereo camera. (Do not perform when performing stereo camera re-adjustment and inspection)
- Using the Subaru Select Monitor, select [Clear adjustment value] from the work support item list of [EyeSight]. Ref. to COMMON (diag)>WORK SUPPORT .
- When [Make the camera adjustment/inspection. Please push OK if ready. Set the ignition switch to OFF after press Cancel at the end of adjustment/inspection mode.] is displayed, select [OK] if preparation is ready.
- After [Clear the adjustment value. CAUTION! Perform this only under the conditions listed in the service information.] is displayed, select [OK].
- When [Clearing adjustment value...] is displayed, wait until it finishes.
- When the adjustment value clear operation is finished correctly, [Adjustment value clear OK! Adjustment value clear is completed. Please to IG OFF more than 5 seconds. (CODE &BYTE03)] is displayed. Select [OK] to finish.
- Turn the ignition switch to OFF and wait for approx. 5 seconds or more.CAUTION: If the ignition switch OFF period is short, the adjustment value clear operation cannot be performed correctly.
- Next, perform the camera all adjustment mode (replacement/removal). Ref. to EYESIGHT>Camera Adjustment, Inspection>PROCEDURE>CAMERA ALL ADJUSTMENT MODE (REPLACEMENT/REMOVAL) .