LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> WRX STI >> Repair and Diagnosis >> Transmission >> Manual Trans >> Manual Transaxle & Differential (TY856) >> Neutral Position Switch >> Installation

Neutral Position Switch: Installation

  1. Install the neutral position switch.
    NOTE: Use a new gasket.

    Tightening torque: 

    32 N.m (3.3 kgf-m, 23.6 ft-lb)

  2. Connect the connector and clip of the neutral position switch.
  3. Install the manual transmission assembly to the vehicle. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL(6MT) (TY85)>MANUAL TRANSMISSION ASSEMBLY>INSTALLATION .
scientia non olet · About LEMON Manuals