LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transaxle & Differential (TY856)) >> Transfer Drive Gear >> Installation

Transfer Drive Gear: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the transfer drive gear.

    Tightening torque: 

    25 N.m (2.5 kgf-m, 18.4 ft-lb)

  2. When the ball bearing, transfer drive gear or snap ring are replaced, select an appropriate adjusting washer for the transfer drive gear. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL(6MT) (TY85)>EXTENSION CASE>ASSEMBLY .
  3. Install the extension case. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL(6MT) (TY85)>EXTENSION CASE>INSTALLATION .
  4. Install the manual transmission assembly to the vehicle. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL(6MT) (TY85)>MANUAL TRANSMISSION ASSEMBLY>INSTALLATION .
scientia non olet · About LEMON Manuals