Section 1 (Engine Starting System & Charging System (2.5L)): General Description: Specification
WARNING: This page is about a different variant/trim than selected.
| Item |
Specifications |
| Starter |
Type |
Reduction type |
| Model |
428000-5760 |
| Manufacturer |
DENSO |
| Voltage and output |
12 V - 1.0 kW |
| Direction of rotation |
Counter Clockwise (when observed from pinion) |
| Number of pinion teeth |
9 |
| Armature commutator runout |
Standard |
0.05 mm (0.0020 in) |
| Limit |
0.10 mm (0.0039 in) |
| Armature depth of segment mold |
Standard |
0.5 mm (0.020 in) |
| Brush length |
Standard |
12.3 mm (0.484 in) |
| Limit |
7.0 mm (0.276 in) |
| Brush spring force |
Standard |
15.9 - 19.5 N (1.62 - 1.99 kgf, 3.57 - 4.38 lbf) |
| Limit |
2.5 N (0.25 kgf, 0.56 lbf) |
| No-load characteristics |
Voltage |
11 V |
| Current |
90 A or less |
| Generator |
Type |
Rotating-field three-phase type, voltage regulator built-in type, each with load response control system |
| Model |
A3TG6591 |
| Manufacturer |
Mitsubishi Electric |
| Voltage and output |
12 V - 110 A |
| Polarity on ground side |
Negative |
| Direction of rotation |
Clockwise (when observed from pulley side) |
| Stator connection |
3-phase Y-type |
| Output current |
1, 500 r/min - 50 A or more |
| 2, 500 r/min - 91 A or more |
| 5, 000 r/min - 105 A or more |
| Regulated voltage |
14.1 - 14.8 V [20°C (68°F)] |
| Rotor slip ring outer diameter |
Standard |
22.7 mm (0.894 in) |
| Limit |
22.1 mm (0.870 in) |
| Brush length |
Standard |
18.5 mm (0.728 in) |
| Limit |
5.0 mm (0.197 in) |
| Battery |
Type |
75D23L |
| Nominal capacity |
5 HR: 53 Ah [25°C (77°F)] |
| Nominal voltage |
12 V |
| CCA |
470 A |
| BCI group number |
35 |