Switch Power Window Sub Rear
WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
- Measure the resistance between terminals of the switch power window sub rear.
- Front seats auto specification
Terminal No. Inspection conditions Standard 1 - 4
5 - 2OFF Less than 1 Ω 2 - 3
3 - 4
1 - 3
3 - 51 MΩ or more 3 - 4
5 - 2Manual up Less than 1 Ω 1 - 4 1 MΩ or more 1 - 4
3 - 2Manual down Less than 1 Ω 5 - 2 1 MΩ or more - All seats auto specification
Terminal No. Inspection conditions Standard 6 - 5 OFF Less than 1 Ω 2 - 1
2 - 5
2 - 61 MΩ or more 2 - 6 Manual up Less than 1 Ω 5 - 6
2 - 5
1 - 21 MΩ or more 2 - 6
1 - 2Auto up Less than 1 Ω 5 - 6
2 - 51 MΩ or more 2 - 5 Manual down Less than 1 Ω 5 - 6
2 - 6
1 - 21 MΩ or more 2 - 5
1 - 2Auto down Less than 1 Ω 5 - 6
2 - 61 MΩ or more
- Front seats auto specification
- Apply battery voltage between the switch power window sub rear terminals to check lighting condition of illumination inside the switch. (All seats auto specification)CAUTION:
When applying battery voltage, do not mix up the positive (+) side and the negative (-) side.
Incorrect polarity connection may cause LED damage inside the switch.
Terminal No. Inspection conditions Standard 7 (+) - 2 (-) Apply battery voltage. Light ON - Replace the switch power window sub rear if it is found defective from the inspection result.