LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (CVT Transaxle (Tr690)) >> Secondary Pressure Sensor >> Installation

Secondary Pressure Sensor: Installation

WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

If water or oil contacts the connector terminal of secondary pressure sensor, replace it with a new part. 

  1. Install a new O-ring.
    NOTE:

    Apply CVTF to the O-rings. 

  2. Using Ko-ken 3/8 12-point 27-mm deep socket (part No. 3305M-27), install the secondary pressure sensor and connect the connector.

    Tightening torque: 

    39 N.m (4.0 kgf-m, 28.8 ft-lb)

  3. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY
  4. Check the CVTF level. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>CVTF>INSPECTION 
scientia non olet · About LEMON Manuals