LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (CVT Transaxle (Tr690)) >> Front Wheel Speed Sensor >> Installation

Front Wheel Speed Sensor: Installation

WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

If water or oil contacts the connector terminal of front wheel speed sensor, replace it with a new part. 

  1. Install the front wheel speed sensor using a new O-ring, and connect the connector.
    NOTE:

    Apply CVTF to the O-rings. 

    Tightening torque: 

    5 N.m (0.5 kgf-m, 3.7 ft-lb)

  2. Install the center exhaust pipe (rear). Ref. to EXHAUST (H4DOTC)>CENTER EXHAUST PIPE>INSTALLATION>CENTER EXHAUST PIPE (REAR)
  3. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY
  4. Check the CVTF level. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>CVTF>INSPECTION 
scientia non olet · About LEMON Manuals