Scavenge Pump: Installation

WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.

Install the scavenge pump.

Set a new O-ring and a scavenge pump to the cylinder block, and tighten the bolt.
CAUTION:
After tightening, check that the scavenge pump is seated on the cylinder block securely.

Tightening torque:

5.9 N.m (0.6 kgf-m, 4.4 ft-lb)

Tighten all the bolts again.

Tightening torque:

6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.

Install the oil jet.
Tightening torque:

6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.
Install the crank sprocket. Ref. to MECHANICAL (H4DOTC)>CRANK SPROCKET>INSTALLATION .
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .