Adjustment Value Clear

Perform when replacing stereo camera. (Do not perform when performing stereo camera re-adjustment and inspection)

1. Using the Subaru Select Monitor, select [Clear adjustment value] in [Work Support] of [EyeSight]. Ref. to COMMON (DIAGNOSTICS)>WORK SUPPORT
2. When [Clear the adjustment value. Caution! Do not perform the procedure with any conditions other than specified in the service information.] is displayed, select [OK].
   NOTE:

   After camera adjustment, the function will be enabled, when the ignition switch is turned to OFF and the system is restarted. 

3. When [Clearing adjustment value...] is displayed, wait until it finishes.
4. When the adjustment value clear operation is finished correctly, [Adjustment value clear OK! The adjustment value clear was finished correctly. Turn the IGN SW to OFF for five seconds or more. (CODE 1F00)] is displayed. Select [OK] to finish.
   CAUTION:

   When [Adjustment value clear NG! The adjustment value clear failed. (CODE 1F01)] or [[4203] Communication error has occurred. Turn OFF the ignition switch and re-adjust] is displayed, check the DTC of stereo camera (current code, history code). Ref. to  COMMON (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) 

5. Turn the ignition switch to OFF and wait for approx. 5 seconds or more.
   CAUTION:

   If the ignition switch OFF period is short, the adjustment value clear operation cannot be performed correctly. 

6. Next, perform the camera all adjustment mode (replacement/removal). Ref. to EYESIGHT>CAMERA ADJUSTMENT, INSPECTION>PROCEDURE>CAMERA ALL ADJUSTMENT MODE (REPLACEMENT/REMOVAL)