Side impact sensor (center pillar)
WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Refer to "CAUTION" of "General Description" before handling the airbag system components. Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION
- Side impact sensor (under the rear center seat) for the airbag system is located under the front center of the rear seat cushion. Be careful not to apply strong impact to the sensor when working with the rear seat cushion removed.
- Before installation, inspect the following items and replace any faulty part with a new part.
- Side impact sensor (center pillar) or connector is damaged.
- Side airbag module has been activated.
- Connect the airbag connector. Ref. to AIRBAG SYSTEM>AIRBAG CONNECTOR>PROCEDURE>EACH IMPACT SENSOR
- Using a new nut, install Side impact sensor (center pillar).CAUTION:
When installing the sensor, insert the set pin on the backside of the sensor into the hole on the body side securely.
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Install the seat belt retractor.
Tightening torque:
Front seat belt: Ref. to SEAT BELT SYSTEM>GENERAL DESCRIPTION>COMPONENT>FRONT SEAT BELT
- Install the trim panel assembly B pillar LWR and cover side sill front Rr. Ref. to EXTERIOR/INTERIOR TRIM>LOWER INNER TRIM>INSTALLATION
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY