Check Roll Connector
CAUTION:
- Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Refer to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
- If the steering wheel and steering angle sensor (steering roll connector) are removed, be sure to perform the following operations.
- Align the center position of the steering roll connector.
- Perform the neutral position setting of the steering angle sensor.
- Turn the ignition switch to OFF.
- Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. Refer to NOTE>NOTE>BATTERY
.NOTE: For model with battery sensor, disconnect the ground terminal from battery sensor.
- Remove the roll connector. Refer to AIRBAG SYSTEM>ROLL CONNECTOR>REMOVAL .
- Measure the resistance between connector terminals.
Preparation tool:
Circuit tester
Terminal No. Inspection conditions Standard A1 - C9 Always Less than 1 Ω - Replace the roll connector if the inspection result is not within the standard value.