LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> WRX Base >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Lighting System >> Rear Height Sensor >> Removal

Rear Height Sensor: Removal

CAUTION: Always remove the sensor assembly - headlight beam leveler before removing any parts related to the suspension.
Do not apply impact to the sensor assembly - headlight beam leveler or forcibly move the arm. Doing so may cause sensor damage and malfunction.
  1. Disconnect the ground cable from battery. Refer to NOTE>NOTE>BATTERY .
    NOTE: For model with battery sensor, disconnect the ground terminal from battery sensor.
  2. Lift up the vehicle.
  3. Remove the rear wheel on the left side.
  4. Remove the sensor assembly - headlight beam leveler.
    CAUTION: Do not disassemble the sensor and lever.
    1. Disconnect the connector.
    2. Remove the nuts, and remove the sensor assembly - headlight beam leveler.
      G08315118Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals