DTC P0112: Intake Air Temperature Sensor 1 Circuit Low Bank 1: Notes

DTC detecting condition: 

Immediately at fault recognition

Trouble symptom: 

• Improper idling
• Poor driving performance

Wiring diagram: 

Engine Electrical System Refer to WIRING SYSTEM>ENGINE ELECTRICAL SYSTEM>WIRING DIAGRAM .

Courtesy of SUBARU OF AMERICA, INC.

1. CHECK CURRENT DATA. 
   1. Start the engine.
   2. Read the value of «IAT Sensor #11» using the Subaru Select Monitor or a general scan tool.
      NOTE:

      • Subaru Select Monitor

        For detailed operation procedures, refer to "Current Data Display For Engine". Refer to ENGINE (DIAGNOSTICS) (W/O STI)>SUBARU SELECT MONITOR .

      • General scan tool

        For detailed operation procedures, refer to the general scan tool operation manual.

   Is the value in «IAT Sensor 120°C (248°F) or more?

   Yes:  Go to  2.

   No:  Even if DTC is detected, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

   NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
2. CHECK HARNESS BETWEEN ECM AND MASS AIR FLOW AND INTAKE AIR TEMPERATURE SENSOR CONNECTOR. 
   1. Turn the ignition switch to OFF.
   2. Disconnect the connector from ECM.
   3. Disconnect the connectors from the mass air flow and intake air temperature sensor.
   4. Measure the resistance between the ECM connector and engine ground.

      Connector & terminal 

      (E158) No. 5 - Engine ground:

   Is the resistance 1 MΩor more?

   Yes:  Replace the mass air flow and intake air temperature sensor. Refer to FUEL INJECTION (FUEL SYSTEMS) (W/O STI)>MASS AIR FLOW AND INTAKE AIR TEMPERATURE SENSOR .

   No:  Repair the ground short circuit of harness between ECM connector and the mass air flow and intake air temperature sensor connector.