LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Outback Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Speed Control System (2.4L)) >> Accelerator Pedal >> Inspection >> Check Accelerator Pedal Sensor Area (Method With SUBARU Select Monitor)

Check Accelerator Pedal Sensor Area (Method With SUBARU Select Monitor)

WARNING: This page is about a different variant/trim than selected.
NOTE: Individual difference of the accelerator pedal may not be corrected sufficiently on the ECM side after DTCs were cleared or the battery was removed and installed on the vehicle. Therefore, when the accelerator opening angle signal does not indicate 100%, repeat the ignition switch ON (engine OFF) and ignition switch OFF operations at intervals of three seconds or more, until the accelerator opening angle signal indicates 100%.
  1. Connect the Subaru Select Monitor.
  2. Turn the ignition switch to ON.
  3. Read the accelerator opening angle and the accelerator sensor voltage using Subaru Select Monitor. Ref. to ENGINE (DIAGNOSTICS) (H4DOTC)>DATA MONITOR .
    Accelerator pedal sensor Accelerator pedal opening angle Standard
    Main 0.0 % 0.4 - 1.0 V
    100.0 % 2.4 - 3.7 V
    Sub 0.0 % 0.4 - 1.0 V
    100.0 % 2.4 - 3.7 V
scientia non olet · About LEMON Manuals