LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Outback Base >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System >> Brake Pipe >> Installation >> Center Brake Pipe

Center Brake Pipe

CAUTION:
  • When installing the brake pipe, do not bend.
  • After installing the brake pipe and brake hose, perform air bleed.
  • After installing the brake hoses, make sure that they do not contact the tires or suspension assembly, etc.
  1. Install the pipe center brake rear.
    1. Install the pipe center brake rear to the pipe clamp and the rear floor.

      Tightening torque: 

      18 N-m (1.8 kgf-m, 13.3 ft-lb)

    2. Install the pipe center brake rear using a flare nut wrench.

      Tightening torque: 

      15 N-m (1.5 kgf-m, 11.1 ft-lb)

  2. Install the support sub frame front.

    Tightening torque: 

    For tightening torque, refer to "COMPONENT" of "General Description" in "REAR. SUSPENSION" article.: Ref. to REAR SUSPENSION>GENERAL DESCRIPTION>COMPONENT>REAR SUSPENSION .

  3. Install the fuel tank.
  4. Install the rear differential.
  5. Install the propeller shaft. Ref. to PROPELLER SHAFT/DRIVE SHAFT/AXLE>PROPELLER SHAFT>INSTALLATION .
  6. Install the rear exhaust pipe.
  7. Install the under cover rear RH. Ref. to EXTERIOR/INTERIOR TRIM>FLOOR UNDER PROTECTOR>INSTALLATION .
  8. Install the adapter cord EPB and sensor sub assembly rear. Ref. to PARKING BRAKE HARNESS .
  9. Install the protector tank.
  10. Install the support crossmember rear RH. Ref. to FRONT SUSPENSION>CROSSMEMBER SUPPORT>INSTALLATION .
  11. Install the rear wheels. Ref. to WHEEL AND TIRE SYSTEM>TIRE AND WHEEL>INSTALLATION .
  12. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
scientia non olet · About LEMON Manuals