Active Test: List
NOTE:
Each output check continues to run for five seconds before stopping automatically.
- Keyless Access with Push Button Start(Power Supply)
| Active test item | Range | Contents | Execution condition |
|---|---|---|---|
| STSW | Output | Turn on the STSW.*2 | - |
| Stop | |||
| ACC | Output | Turn on the ACC. | - |
| Stop | |||
| IGN1/2 | Output | Turn on the IGN1/2. | - |
| Stop | |||
| Start SW character illumination lighted | Output | Perform ON output of the push button ignition switch backup light.* 1 | - |
| Stop | |||
| Start SW indicator lighted (green) | Output | Perform ON output of the push button ignition switch backup light.* 1 | - |
| Stop | |||
| Start SW indicator lighted (orange) | Output | Perform ON output of the push button ignition switch backup light.* 1 | - |
| Stop |
*1: When lit by a condition other than for active test, it will not become unlit even when set to either OFF or no output.
*2: When performed with ignition switch ON, engine will start. Therefore, great care must be exercised.
- Keyless Access with Push Button Start(Collation)
| Active test item | Range | Contents | Execution condition |
|---|---|---|---|
| Driver seat sensor power supply | Output | Perform the output check for the driver's door touch sensor. | - |
| Stop | |||
| Passenger seat sensor power supply | Output | Perform the output check for the passenger's door touch sensor. | - |
| Stop | |||
| Steering lock power supply | Output | Output the power supply signal from keyless access control module to steering lock control module. | - |
| Stop |