Inspection Mode 1
| DTC | Description and trouble part | Note |
|---|---|---|
| B2602 | Vehicle Speed Control | - |
| B2603 | EPB Control | - |
| B2605 | Battery Control Low | - |
| B2607 | SEAT MOTOR RELAY FAILURE | - |
| B2608 | SEAT SW FAILURE | - |
| B2609 | IG | - |
| B260B | SEAT POSITION GAP | - |
| B260C | CONTROL MODULE COMMUNICATION STUCK | - |
Diagnostic procedure:
- Using the Subaru Select Monitor, perform the clear memory of [Power Seat Memory]. Ref. to COMMON (DIAG)>CLEAR MEMORY .
- Using the Subaru Select Monitor, read the DTC of [Power Seat Memory] to check that there is no DTC displayed. Ref. to Power Seat Memory System (Diagnostics)>Diagnostic Trouble Code (DTC) .NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis for the displayed DTCs. After solving the DTC, repeat from step 1).
- Turn the ignition switch ON → OFF, and wait for 45 seconds or more.
- Turn the ignition switch OFF → ON, and wait for 5 seconds or more.
- Using the Subaru Select Monitor, read the DTC of [Power Seat Memory] to check that there is no DTC displayed. Ref. to Power Seat Memory System (Diagnostics)>Diagnostic Trouble Code (DTC) .NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis for the displayed DTCs.