Rear Finisher Light Assembly: Inspection

Apply battery voltage between the connector terminals to check the lighting condition of the light.

CAUTION: When applying battery voltage, do not mix up the positive (+) side and the negative (-) side.
Incorrect polarity connection may cause internal LED damage.

Sedan model

Courtesy of SUBARU OF AMERICA, INC.

Back-up light

Terminal No.	Inspection conditions	Specification
2 (+) - 1 (-)	Apply battery voltage.	Back-up light on

Tail light (model with tail light)

Terminal No.	Inspection conditions	Specification
2 (+) - 1 (-)	Apply battery voltage.	Tail light on

OUTBACK model

Model without tail light

Courtesy of SUBARU OF AMERICA, INC.

Terminal No.	Inspection conditions	Specification
2 (+) - 1 (-)	Apply battery voltage.	Back-up light on

Model with tail light

Courtesy of SUBARU OF AMERICA, INC.

Terminal No.	Inspection conditions	Specification
2 (+) - 1 (-)	Apply battery voltage.	Back-up light on
4 (+) - 3 (-)	Apply battery voltage.	Tail light on

Replace the harness and bulb if it is found defective.
NOTE: Since LED (Light Emitting Diode) is used for the tail light, replace the finisher light assembly if the light does not illuminate.