Rear Disc Brake Assembly: Assembly
NOTE:
If the brake hose rear is disconnected, air enters inside. Therefore, this operation should be performed on the vehicle without disconnecting the brake hose rear.
- Check each part. Ref. to BRAKE>Rear Disc Brake Assembly>INSPECTION .
- Install the pin boot.
- Apply a coat of grease to the inside of the new boot piston.
Preparation items:
Grease: Nippon Grease NIGLUBE RX-2 or equivalent
- Using the ST, install the boot piston.
Preparation tool:
ST: PISTON BOOT INSTALLER (99099AL000)