Initialize Operation

CAUTION: During initialization, perform the position learning and the sliding learning. Sliding learning mode can not be initiated unless the position learning is performed.

NOTE: When initialize operation is performed, it is necessary to press the switch repeatedly as it operates for only at the moment when the switch is pressed, even when the switch is held down.

Position learning
1. Position the lid assembly at the full close position, and press and hold the close switch for ten seconds.
2. The motion of the glass lid shifts to inching operation until it reaches the mechanical lock position. After that, it returns to the full close position and then stops.
3. Release the close switch to finish the position learning.
  - Sliding learning
4. Within six seconds after the position learning is finished, press and hold the close switch again.
5. The lid assembly moves to the full close position, full open position, and the full close position successively, and stops at the full close position.
6. Release the close switch and turn the IG to OFF to finish the initializing.