Sunroof Assembly: Installation
CAUTION:
- Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
- For installation of the cover assembly stereo camera, refer to "INSTALLATION", "Stereo Camera" in the "EyeSight" service information and observe the precautions for installation. Ref. to EYESIGHT>STEREO CAMERA>INSTALLATION .
- Be careful not to snag the harness.
- Connect the harness connector firmly.
- Install each connector and the tube drain.
Tightening torque:
Connector holder: 7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
Ground bolt: 13 N.m (1.3 kgf-m, 9.6 ft-lb)
- Install the bracket sunroof and the frame sunroof.
Tightening torque:
6 N.m (0.61 kgf-m, 4.4 ft-lb)
- Install the bolt which secures the curtain airbag module.
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Connect the harness connector of the tube drain and the motor assembly.CAUTION: Insert the tube drain until it contacts the end of drain pipe (a).
- Install the trim panel sub assembly. Ref. to EXTERIOR/INTERIOR TRIM>ROOF TRIM>INSTALLATION .
- Install the lid assembly. Ref. to SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF)>Glass Lid>INSTALLATION>GLASS LID .
- Connect the ground terminal to battery sensor. Ref. to GROUND TERMINAL REMOVAL OR INSTALLATION .