Rear Gate Light: Inspection

Measure the resistance between connector terminals.

Preparation tool:

Circuit tester

Courtesy of SUBARU OF AMERICA, INC.

Terminal No.	Inspection conditions	Standard
2 - 3	Switch OFF	1 MΩ or more
2 - 3	Switch door	Approx. 18 Ω

Apply battery voltage between the connector terminals to check the lighting condition of the light.

Terminal No.	Inspection conditions	Specification
2 (+) - 3 (-)	Switch OFF	Light OFF
2 (+) - 3 (-)	Switch door	Light ON

If the inspection result is not within the standard, replace the light assembly rear gate.
NOTE: Since LED (Light Emitting Diode) is used for the light assembly rear gate, replace the light assembly rear gate if the light does not illuminate.