Telematics Button
- Check the button.
- Measure the resistance between connector terminals.
Preparation tool:
Circuit tester
- SOS button
Terminal No. Inspection conditions Standard 6 - 1 OFF Approx. 1.6 kΩ ON Less than 1 Ω - i-button
Terminal No. Inspection conditions Standard 3 - 1 OFF Approx. 1.6 kΩ ON Less than 1 Ω - Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.CAUTION: When applying battery voltage, do not mix up the positive (+) side and the negative (-) side .
Incorrect polarity connection may cause LED damage inside the switch.
Terminal No. Inspection conditions Specification 8 (+) - 2 (-) Apply battery voltage. Light ON - Measure the resistance between connector terminals.
- Check the indicator.
- Apply battery voltage between the connector terminals to check the lighting condition of the indicator.
CAUTION: When applying battery voltage, do not mix up the positive (+) side and the negative (-) side .
Incorrect polarity connection may cause LED damage inside the switch .Terminal No. Inspection conditions Specification 4 (+) - 1 (-) Apply battery voltage. Illuminating in green 7 (+) - 1 (-) Illuminating in red 4 (+) - 1 (-) and 8 (+) - 2 (-) Apply battery voltage simultaneously. Indicator turns on in dimmed condition at one level. 7 (+) - 1 (-) and 8 (+) - 2 (-) - Replace the telematics button if it is found defective.