DTC P081A: Starter Disable Circuit Low: Notes

1. -

DTC detecting condition: 

Immediately at fault recognition

Trouble Symptom: 

Failure of engine to Start

Wiring diagram: 

Engine Electrical System Ref. to WIRING SYSTEM>ENGINE ELECTRICAL SYSTEM .

• Model without push button start

Courtesy of SUBARU OF AMERICA, INC.

Courtesy of SUBARU OF AMERICA, INC.

• Model with push button Start

Courtesy of SUBARU OF AMERICA, INC.

Courtesy of SUBARU OF AMERICA, INC.

1. CHECK HARNESS BETWEEN ECM AND M/B (STARTER CUT RELAY) (SHORT TO GROUND)  .
   1. Turn the ignition switch to OFF.
   2. Disconnect the connector from ECM.
   3. Remove the Starter cut relay.
   4. Measure the resistance between the ECM connector and engine ground.

      Connector and terminal 

      (B134) No. 24 - Engine ground:

   Is the resistance 1 MΩ or more?

   Yes  : Go to  2 .

   No  : Repair the short circuit to ground in harness between ECM connector and M/B (starter cut relay).

2. CHECK HARNESS BETWEEN ECM AND M/B (STARTER CUT RELAY) (OPEN)  .

   Measure the resistance of harness between ECM connector and M/B (starter cut relay) terminal.

   Connector and terminal 

   (B134) No. 24 - No. 4:

   Is the resistance less than 1 Ω?

   Yes  : Go to  3 .

   No  : Repair the open circuit of harness between ECM connector and M/B (starter cut relay) connector.

3. CHECK STARTER CUT RELAY  .

   Check the starter cut relay. Ref. to STARTING/CHARGING SYSTEMS (H4DO)>STARTER RELAY>INSPECTION .

   Is the check result OK?

   Yes  : Repair the poor contact of ECM connector.

   No  : Replace the starter cut relay. Ref. to STARTING/CHARGING SYSTEMS (H4DO)>STARTER RELAY>LOCATION .