DTC P05A2: Active Grille Air Shutter "A" Control Circuit/Open: Notes

1. -

DTC detecting condition:

Immediately at fault recognition

NOTE: After the faulty parts are repaired or replaced, perform the final check in Basic Diagnostic Procedure. Ref. to ENGINE (DIAGNOSTICS) (H4DO)>BASIC DIAGNOSTIC PROCEDURE>PROCEDURE .

CHECK DTC .
1. Turn the ignition switch to ON.
2. Using the Subaru Select Monitor or a general scan tool, perform the clear memory of [Engine].
  Ref. to COMMON (DIAG)>CLEAR MEMORY .
3. Turn the ignition switch to OFF, and wait for approx. 30 seconds.
4. Turn the ignition switch to ON.
5. Using the Subaru Select Monitor or a general scan tool, read the DTC of [Engine].
  Ref. to COMMON (DIAG)>DIAGNOSTIC TROUBLE CODE (DTC) .
Is DTC P05A2 displayed? (Current malfunction)

Yes : Replace the active grille shutter. Ref. to COOLING (H4DO)>ACTIVE GRILLE SHUTTER .

No : Using the Subaru Select Monitor, perform the operation check for the active grille shutter to make sure that its open and close operation can be completed properly.

NOTE: For detailed operation procedures, refer to the "Active Test". Ref. to ENGINE (DIAGNOSTICS) (H4DO)>ACTIVE TEST .