DTC P0336: Crankshaft Position Sensor "A" Circuit Range/Performance: Notes

1. -

DTC detecting condition:

Detected when two consecutive driving cycles with fault occur.

Trouble symptom:

Engine stall
Failure of engine to start

NOTE: After the faulty parts are repaired or replaced, perform the final check in Basic Diagnostic Procedure. Ref. to ENGINE (DIAGNOSTICS) (H4DO)>BASIC DIAGNOSTIC PROCEDURE>PROCEDURE .

CHECK CONDITION OF CRANKSHAFT POSITION SENSOR .
Check the installation condition of crankshaft position sensor.

Is the crankshaft position sensor installation bolt tightened securely?

Yes : Go to 2 .

No : Tighten the crankshaft position sensor installation bolt securely. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>CRANKSHAFT POSITION SENSOR>INSTALLATION .
CHECK CRANKSHAFT POSITION SENSOR PLATE .
Check the crankshaft position sensor plate.

Is there crack or damage in the crankshaft position sensor plate teeth?

Yes : Replace the crankshaft position sensor plate. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>CRANKSHAFT POSITION SENSOR PLATE .

No : Go to 3 .
CHECK INSTALLATION CONDITION OF TIMING CHAIN .
Turn the crankshaft, and align alignment mark on crank sprocket with alignment mark on cylinder block.

ST 18252AA000 CRANKSHAFT SOCKET

Is the timing chain dislocated from its proper position?

Yes : Correct the installation condition of timing chain. Ref. to MECHANICAL (H4DO)>TIMING CHAIN ASSEMBLY .

No : Replace the crankshaft position sensor. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>CRANKSHAFT POSITION SENSOR .