DTC P0072: Ambient Air Temperature Sensor Circuit "A" Low: Notes

1. -

DTC detecting condition:

Immediately at fault recognition

NOTE: After the faulty parts are repaired or replaced, perform the final check in Basic Diagnostic Procedure. Ref. to ENGINE (DIAGNOSTICS) (H4DO)>BASIC DIAGNOSTIC PROCEDURE>PROCEDURE .

CHECK DTC .
1. Turn the ignition switch to ON.
2. Using the Subaru Select Monitor or a general scan tool, read the DTC of [Engine]. Ref. to COMMON (DIAG)>DIAGNOSTIC TROUBLE CODE (DTC) .
Is DTC P0072 or P0073 displayed? (Current malfunction)

Yes : Go to 2 .

No : Even if DTC is detected, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
CHECK COMBINATION METER .
Check the combination meter system. Ref. to COMBINATION METER (DIAGNOSTICS)>BASIC DIAGNOSTIC PROCEDURE .

Is the check result OK?

Yes : Repair the poor contact of ECM connector.

No : Repair the combination meter system. Ref. to INSTRUMENTATION/DRIVER INFO>COMBINATION METER .