DTC B2B39: RR Door Power Window Control Module EEPROM
DTC detecting condition:
When one of the following data cannot be read from the non-volatile memory as the CPU is reset.
- Window position
- Sliding learn value
- Initialization completed state
- Full open stop position
Trouble symptom:
- When the power window sub-switch is operated, the rear right window does not work.
- When the power window sub-switch is operated, the rear right window rolls down only in manual down operation, or inches up. (Inch up: Operating the switch rolls up the window about 10 mm only)
CAUTION:
Before performing diagnosis, refer to "CAUTION" in "General Description". Ref. to POWER WINDOW (DIAGNOSTICS)>General Description>CAUTION .
- INITIALIZATION USING THE POWER WINDOW SWITCH (REAR SEAT RH)
.
- Perform initialization using the power window switch. Ref. to POWER WINDOW (DIAGNOSTICS)>Work Support>NOTE .
- Read the DTC of [Power Window (Rear Right)] using the Subaru Select Monitor. Ref. to POWER WINDOW (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .
Is DTC B2B39 displayed? (Current malfunction)
Yes: Go to 2 .
No: Even if DTC is displayed, the circuit has returned to a normal condition at this time.
Reproduce the failure, and then perform the diagnosis again.
NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause. - SYSTEM INITIALIZATION
.
- Using the Subaru Select Monitor, perform [System Initialization] of [Power Window (Rear Right)]. Ref. to POWER WINDOW (DIAGNOSTICS)>Work Support>OPERATION>SYSTEM INITIALIZATION .NOTE: Record the DTCs and FFD because they will be erased when the initialization is performed.
- Read the DTC of [Power Window (Rear Right)] using the Subaru Select Monitor. Ref. to POWER WINDOW (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .
Is DTC B2B39 displayed? (Current malfunction)
Yes: Replace the rear regulator and motor assembly RH. Ref. to GLASS/WINDOWS/MIRRORS>REAR REGULATOR AND MOTOR ASSEMBLY .
No: Even if DTC is displayed, the circuit has returned to a normal condition at this time.
Reproduce the failure, and then perform the diagnosis again.
NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause. - Using the Subaru Select Monitor, perform [System Initialization] of [Power Window (Rear Right)]. Ref. to POWER WINDOW (DIAGNOSTICS)>Work Support>OPERATION>SYSTEM INITIALIZATION .