Inspection Mode Am

DTC	Description and trouble part	Condition	Number of driving cycles on the detecting condition
P0071	AMBIENT AIR TEMPERATURE SENSOR CIRCUIT "A" RANGE/PERFORMANCE	6 hours or more have elapsed since ignition switch is OFF under a completely warmed up condition.	2
P0111	INTAKE AIR TEMPERATURE SENSOR 1 CIRCUIT RANGE/PERFORMANCE BANK 1		2
P0116	ENGINE COOLANT TEMPERATURE SENSOR 1 CIRCUIT RANGE/PERFORMANCE		2
P0196	ENGINE OIL TEMPERATURE SENSOR "A" RANGE/PERFORMANCE		2
P040B	EGR TEMPERATURE SENSOR "A" CIRCUIT RANGE/PERFORMANCE		2
P050A	COLD START IDLE CONTROL SYSTEM PERFORMANCE	-	2
P050B	COLD START IGNITION TIMING PERFORMANCE	-	2
P24B9	EVAP SYSTEM LEAK DETECTION PUMP PRESSURE SENSOR CIRCUIT RANGE/PERFORMANCE	60 seconds or more have elapsed since ignition switch is OFF.	2

Check that the battery voltage is 12 V or more and fuel remains approx. half [20 - 40 L (5.3 - 10.6 US gal, 4.4 - 8.8 Imp gal)].
Using the Subaru Select Monitor, perform the clear memory of [Engine]. Ref. to COMMON (DIAG)>CLEAR MEMORY .
With the ignition switch ON (engine stopped), read the values in [Engine Coolant Temperature] and [Intake Air Temp.] using the Subaru Select Monitor. Ref. to COMMON (DIAG)>DATA MONITOR .
If the values from step 3) satisfy the following conditions, navigate to Inspection Mode for measuring Exhaust Gas. Ref. to P-HEV HYBRID POWERTRAIN CONTROL (DIAGNOSTICS)>WORK SUPPORT>OPERATION>SERVICE MODE .
Condition:

|Engine coolant temperature - Intake air temperature | 5°C (9°F) or more
NOTE:
- If the conditions are not satisfied, turn the ignition switch to OFF and wait until the parameters are satisfied .
- Hold the select lever in "P" range or "N? range during engine start .
- If it is necessary to run the engine for 10 minutes or more, fasten the driver's seat belt .
Start the engine and wait for 30 seconds.
Read the temporary code using the Subaru Select Monitor or general scan tool. Ref. to COMMON (DIAG)>DIAGNOSTIC TROUBLE CODE (DTC) .