Active Test: List
| Active test items | Contents | Execution condition |
|---|---|---|
| Fuel Pump Relay | ON/OFF of the fuel pump can be set. | Ignition switch ON (engine OFF) |
| CPC Solenoid Valve | ON/OFF of the purge control solenoid valve can be set. | |
| Radiator Fan Relay | ON/OFF of the radiator fan relay can be set. | |
| ELCM switching valve | ON/OFF of the leak check valve assembly switching valve can be set. | |
| ELCM pump | ON/OFF of the leak check valve assembly vacuum pump can be set. | |
| Fuel Pump Control (OFF Drive) | Fuel pump can be set to OFF. | Non-load idling*1 |
| Fixed Idle Ignition Timing | Ignition timing is set depending on the engine speed. | |
| Idle Speed Control | Idle speed can be set.
CAUTION:
Idle speed can be set up to 500 rpm at the Subaru Select Monitor. However, do not set to 1000 rpm or less.
|
|
| Injection Stop Mode (Injector 1) Injection Stop Mode (Injector 2) Injection Stop Mode (Injector 3) Injection Stop Mode (Injector 4) | Injector of each cylinder can be set to stop the fuel injection. | |
| Injection Quantity Control | The amount of fuel injection can be set. | |
| EGR Valve Control (Step) | STEP number of the EGR control valve can be set. | |
| Active Grille Shutter Control*2 | Open ←→ close of the active grille shutter can be set. |
|
| Electric Vent Solenoid Value | Open/close status of the valve that seals the fuel tank is displayed. Open: Not sealed Close: Sealed |
|
| Fuel Filler Lid Lock Solenoid Relay Output | Operating status of the relay that drives the lock assembly fuel is displayed. ON: Opens the fuel lid OFF: Does not open the lock assembly fuel |
|
- *1 : A condition where Inspection Mode for measuring Exhaust Gas is initiated before starting engine and the following data monitor items are ON after starting engine corresponds to non-load idling. Ref. to P-HEV HYBRID POWERTRAIN CONTROL (DIAGNOSTICS)>WORK SUPPORT>OPERATION>SERVICE MODE . Ref. to ENGINE (DIAGNOSTICS) (H4DO(HEV))>DATA MONITOR .
- Service mode
- Engine self-sustaining judgment
- *2 : After replacing ECM or active grille shutter, be sure to perform this procedure.