Front Camber

1. Adjust the camber angle to the following value.

   Model	Camber (difference between RH and LH 35' or less)
   Impreza model	-0°30'±0°30'
   Crosstrek model	0°00'±0°30'

2. Loosen the nut side, while holding the front strut assembly bolt side. (2 places at upper and lower)
3. Turn the adjusting bolt so that the camber is set at specification.
   NOTE: Moving the adjusting bolt by one scale changes the camber by approximately 0°10'.

   Courtesy of SUBARU OF AMERICA, INC.

   To increase camber.
   Rotate the left side counterclockwise.	Rotate the right side clockwise.
   Courtesy of SUBARU OF AMERICA, INC.	Courtesy of SUBARU OF AMERICA, INC.

   To decrease camber.
   Rotate the left side clockwise.	Rotate the right side counterclockwise.
   Courtesy of SUBARU OF AMERICA, INC.	Courtesy of SUBARU OF AMERICA, INC.

4. Tighten two new nuts.

Tightening torque: 

155 N.m (15.8 kgf-m, 114.3 ft-lb)