LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Crosstrek Base, Standard Trans >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag System >> Side Airbag Sensor >> Installation

Side Airbag Sensor: Installation

  1. Before installation, inspect the following items and replace any faulty part with a new part.
    • The side airbag sensor, sensor bracket, or connector are damaged.
    • Side airbag module has been activated.
  2. Install the side airbag sensor.
    CAUTION:
    • Do not reuse the bolt and nut. Always replace with the specified new bolts and nuts.
    • When installing the sensor, insert the set pin on the backside of the sensor into the hole on the body side securely.

    Tightening torque: 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb)

  3. Install the seat belt retractor.

    Tightening torque: 

    Front seat belt: Ref. to SEAT BELT SYSTEM>GENERAL DESCRIPTION>COMPONENT>FRONT SEAT BELT .

  4. Install the cover side sill - front INN, cover side sill - rear INN, and trim panel - center pillar LWR.
  5. Install the rear seat cushion assembly.
  6. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
    NOTE: For the hybrid model, connect the battery negative terminal.
scientia non olet · About LEMON Manuals