LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Crosstrek Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Brake Control System (Diagnostics) (HEV)) >> Diagnostic Procedure With Diagnostic Trouble Code (DTC) >> DTC C1455: Power Unit Torque Range/Performance

DTC C1455: Power Unit Torque Range/Performance

WARNING: This page is about a different variant/trim than selected.

DTC Detecting condition: 

A fault is detected if an abnormal value in a torque-related signal from the HEV or electric brake booster is received for the predetermined time.

Trouble symptom: 

  1. CHECK HYBRID VEHICLE CONTROL ECM  .
    1. Start the engine.
    2. Read the DTC of [P-HEV Hybrid Powertrain Control] using the Subaru Select Monitor. Ref. to P-HEV HYBRID POWERTRAIN CONTROL (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .

    Are any DTCs displayed?

    Yes:  Perform the diagnosis according to the DTC. Ref. to P-HEV HYBRID POWERTRAIN CONTROL (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC)>LIST .

    No:  Go to  2.

  2. CHECK ELECTRIC BRAKE BOOSTER  .
    1. Start the engine.
    2. Read the DTC of [Electric Brake Booster] using the Subaru Select Monitor. Ref. to ELECTRIC BRAKE BOOSTER (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .

    Are any DTCs displayed?

    Yes:  Perform the diagnosis according to the DTC. Ref. to ELECTRIC BRAKE BOOSTER (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC)>LIST .

    No:  Go to  3.

  3. CHECK VDCCM AND H/U  .
    1. Using the Subaru Select Monitor, perform the clear memory of [Brake Control]. Ref. to COMMON (DIAG)>CLEAR MEMORY .
    2. Execute the inspection mode. Ref. to BRAKE CONTROL (DIAGNOSTICS) (HEV)>INSPECTION MODE .
    3. Read the DTC of [Brake Control] using the Subaru Select Monitor. Ref. to BRAKE CONTROL (DIAGNOSTICS) (HEV)>DIAGNOSTIC TROUBLE CODE (DTC) .

    Is the same DTC displayed?

    Yes:  Replace the VDCCM and H/U. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM & H/U) .

    No:  Go to  4.

  4. CHECK DETECTION OF OTHER DTCS FOR VDC  .

    Read the DTC of [Brake Control] using the Subaru Select Monitor. Ref. to BRAKE CONTROL (DIAGNOSTICS) (HEV)>DIAGNOSTIC TROUBLE CODE (DTC) .

    Is any other DTC displayed?

    Yes:  Perform the diagnosis according to the DTC. Ref. to BRAKE CONTROL (DIAGNOSTICS) (HEV)>DIAGNOSTIC TROUBLE CODE (DTC)>LIST .

    No:  Currently, it is normal. There may have been a temporary poor contact in the harness and connector or a temporary noise interference.