Inspection Mode E
WARNING: This page is about a different variant/trim than selected.
| DTC | Description and trouble part | Condition | Number of driving cycles on the detecting condition |
|---|---|---|---|
| P0461 | FUEL LEVEL SENSOR "A" CIRCUIT RANGE/PERFORMANCE | - | 2 |
WARNING:
When performing inspection mode E on a public road, pay sufficient attention to the traffic condition and give the highest priority to safe driving.
- Make sure that the battery voltage is 12 V or more.
- Using the Subaru Select Monitor, perform the clear memory of [Engine]. Ref. to COMMON (DIAG)>CLEAR MEMORY .
- Drive for approximately 30 L (7.9 US gal, 6.6 Imp gal) of fuel.NOTE:
- It is acceptable to drive the vehicle intermittently .
- Do not disconnect the battery terminals while diagnosing. (Data will be cleared by disconnecting the battery terminals.)
- Read the temporary code using the Subaru Select Monitor or general scan tool. Ref. to COMMON (DIAG)>DIAGNOSTIC TROUBLE CODE (DTC) .