LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> CVT Transaxle (Tr580 CROSSTREK) >> Inhibitor Switch >> Installation

Inhibitor Switch: Installation

  1. Temporarily connect the inhibitor switch, and connect the connector.
  2. Install the shifter arm and fix with a new spring pin.
  3. Connect the select cable.
    CAUTION:

    Do not apply excessive load while holding the part (a). 

    G13591814Courtesy of SUBARU OF AMERICA, INC.
    NOTE:

    Set the washer before installing the snap pin. 

    Tightening torque: 

    25 N.m (2.5 kgf-m, 18.4 ft-lb)

    G13225470Courtesy of SUBARU OF AMERICA, INC.
  4. Adjust the inhibitor switch. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR580 CROSSTREK)>INHIBITOR SWITCH>ADJUSTMENT .
  5. Shift the select lever to "P range".
  6. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
scientia non olet · About LEMON Manuals