Recommended Materials: Grease

ENGINE OIL
CAUTION:
- Use 0W-20 (synthetic oil).
- It is acceptable to fill with an engine oil of another brand, but make sure to use the following engine oil specified by SUBARU CORPORATION.
Engine oil standard

Courtesy of SUBARU OF AMERICA, INC.

Those with SN or SN PLUS "Resource Conserving" logo in case of API standard.

Courtesy of SUBARU OF AMERICA, INC.

Those with GF-5 "starburst mark" displayed on top of the container in case of ILSAC standard.

SAE viscosity No. and applicable temperature

0W-20 (synthetic oil) specified

Courtesy of SUBARU OF AMERICA, INC.

ENGINE COOLANT

NOTE: The SUBARU Super Coolant contains anti-freeze and anti-rust agents, and is especially made for Subaru engines with an aluminum cylinder block. Be sure to use SUBARU Super Coolant, since other coolant may cause corrosion.

Item	Recommended materials	Item number	Alternative
Engine coolant	SUBARU SUPER COOLANT (concentrated type)	-	-
Engine coolant	SUBARU SUPER COOLANT (diluted type)	K0670Y0001	-
Water for dilution	Distilled water	-	Soft water or tap water
Cooling system protective agent	Cooling system conditioner	SOA345001	-

CVTF
CAUTION: Always use specified CVTF. Using fluid other than specified CVTF will cause malfunction.

Subaru High Torque CVT Fluid LV
DIFFERENTIAL GEAR OIL
CAUTION: Do not mix different kinds of oil.
- Front differential
  SUBARU GEAR OIL EXTRA MT or equivalent (GL-5 (75W-90))
- Rear differential (VB3-type)
  SUBARU GEAR OIL EXTRA MT or equivalent (GL-5 (75W-90))
BRAKE FLUID
CAUTION: Do not mix different kinds of brake fluid.
Mixing different brands of fluid, or mixing different grades of fluid (even if they have the same brand name), may lead to severe accidents due to reduced brake fluid performance.

FMVSS No. 116 DOT3 or DOT4

GREASE

Use grease and supplementary lubricants shown in the table below.

Item	Application point	Application point	Recommended materials (item No.)
Supplementary lubricants	Exhaust	Oxygen sensor	Spray type lubricant (004301003)
Grease	CVT	Select lever	Multemp D
	Drive shaft	Front drive shaft (IN side)	NKG302
		Front drive shaft (OUT side)	NKG814
		Rear drive shaft	NKG814
	Brake	Brake pedal	Multemp TAS No. 2
	Brake	Clevis pin connecting the operating rod and brake pedal	Shell Gadus S2 V220
	Steering	Steering gearbox (rack and pinion)	Multemp AC-P
	Steering	Steering gearbox (boot and tie-rod installation parts)	SILICONE GREASE G-40M