Sunroof Motor: Installation

CAUTION:

For installation of the stereo camera cover assembly, refer to "INSTALLATION", "Stereo Camera" in the "EyeSight" information and observe the precautions for installation . Ref. to EyeSight>Stereo Camera>INSTALLATION .
When installing the motor assembly, be careful not to move the cable assembly .

Install the motor assembly.
Tightening torque:

5.4 N.m (0.6 kgf-m, 4.0 ft-lb)
Install the trim panel sub assembly. Ref. to EXTERIOR/INTERIOR TRIM>Roof Trim>INSTALLATION .
Install the stereo camera cover assembly. Ref. to EYESIGHT>Stereo Camera>INSTALLATION .
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Perform the initialize operation. Ref. to SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF)>Sunroof Control System>OPERATION>INITIALIZATION .
Check the operation of sunroof by following the table below.

Operation	Switch position
(1) Lid assembly front closes completely.	Close
(2) Lid assembly front is tilted up to the top position.	Tilt up
(3) Lid assembly front closes completely.	Tilt down
(4) Lid assembly front opens completely.	Open
(5) Lid assembly front closes completely.	Close

Operation	Switch position
(1) Shade assembly opens completely.	Open
(2) Shade assembly closes completely.	Close