LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> WRX Limited, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Front Suspension And Wheel Alignment) >> Stabilizer >> Removal >> Stabilizer

Section 35 (Front Suspension And Wheel Alignment): Stabilizer: Removal: Stabilizer

WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the under guard front. Ref. to EXTERIOR/INTERIOR TRIM>FRONT UNDER COVER> REMOVAL .
  3. Remove the crossmember support rear LH. Ref. to FRONT SUSPENSION>CROSSMEMBER SUPPORT>REMOVAL .
  4. Remove the center exhaust pipe (rear). Ref. to EXHAUST (H4DOTC)>CENTER EXHAUST PIPE>REMOVAL>CENTER EXHAUST PIPE (REAR) .
  5. Remove the nut and disconnect the stabilizer link front (lower part).
    G14601727Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the stabilizer front.
    1. Remove the bolt and nut, and remove the clamp stabilizer.
    2. Remove the rubber bushing stabilizer front.
    3. Remove the stabilizer front.
G14601728Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals