LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Outback Base >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Air Bag System (Service Information) >> Passenger's Airbag Module >> Installation

Passenger's Airbag Module: Installation

CAUTION:
  • Before handling the airbag system components, refer to AIRBAG SYSTEM>General Description>CAUTION .
  • Do not allow harness and connectors to interfere or get tangled up with other parts.
  • When reusing the tether clip on the upper part of the trim panel assembly A pillar, check that there is no damage to the tether clip. If the tether clip is damaged, always replace it with a new tether clip. If the tether clip is damaged, its holding force is reduced and the trim panel assembly A pillar may come off.
  1. Before installation, inspect the following items and replace any faulty part with a new one.
    • Passenger's airbag lid (instrument panel surface) is cracked or deformed.
    • Airbag module is cracked or deformed.
    • Harness and/or connector is cracked, deformed or open.
    • Harness wire is exposed.
    • Mounting bracket is cracked or deformed.
  2. Install the passenger's airbag module, and connect the connector.

    Tightening torque:  7.5 N.m (0.8 kgf-m, 5.5 ft-lb)

  3. Install the instrument panel assembly. Refer to EXTERIOR/INTERIOR TRIM>Instrument Panel Assembly>INSTALLATION .
  4. Connect the ground terminal to battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .
    NOTE: After connecting the ground terminal to the battery sensor, place the select lever in the "P" position.
scientia non olet · About LEMON Manuals